[PSUBS-MAILIST] G.L. summary Pressure Hull

[Dan H.]

If you don't have a taper attachment, use the compound slide on the lathe.  It's tricky to set since your working on fractions of a degree for a good fit but you fine tune it with a few trial pieces.  

Dan H.
  ----- Original Message ----- 
  From: hank pronk 
  To: Personal Submersibles General Discussion 
  Sent: Thursday, December 12, 2013 10:16 AM
  Subject: Re: [PSUBS-MAILIST] G.L. summary Pressure Hull


  Does anyone have a trick to machining an inside taper without lathe  attachments.  I need to make a hub to fit a tapered shaft.  I made one by trial and error and it will work but it is not perfect. 
  Hank 



  On Thursday, December 12, 2013 7:13:39 AM, Jon Wallace <jonw at psubs.org> wrote:


  I should have stated up front that we were just having some fun and I hope nobody concentrating on ROV/AUV development and operation takes offense.  PSUBS welcomes ROV and AUV discussions here as well.

  Jon



  On 12/11/2013 9:57 PM, Alan James wrote:

    Thanks Keith,
    hope didn't see the phone sex & ROV comments
    earlier 
    Keith owns a ROV company.
    Alan






  _______________________________________________
  Personal_Submersibles mailing list
  Personal_Submersibles at psubs.org
  http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles






------------------------------------------------------------------------------


  _______________________________________________
  Personal_Submersibles mailing list
  Personal_Submersibles at psubs.org
  http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.whoweb.com/pipermail/personal_submersibles/attachments/20131212/c47fd8e7/attachment.html>