[PSUBS-MAILIST] Jon's new penetrators

Mon Feb 15 10:25:53 EST 2016

Jon, do you have a copy of the Machinery's Handbook? Standard fits and tolerances for hole based and shaft based fits in nominal sizes in both inch and metric are covered. I can look it up for you on Tuesday if you like. Regardless, get a copy of that book if you don't have one.

Sean

On February 15, 2016 6:46:53 AM MST, Jon Wallace via Personal_Submersibles <personal_submersibles at psubs.org> wrote:
>
>I'm looking for a clearance recommendation between shaft and bore that 
>provides for easy shaft insertion but very little slop side to side.  I
>
>promise I am not being sexually provocative here, just trying to get 
>specs for an electrical penetrator.  If the bore is 1 inch diameter 
>let's say, would I want to spec out .95?  .995?
>
>Jon
>
>
>_______________________________________________
>Personal_Submersibles mailing list
>Personal_Submersibles at psubs.org
>http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.whoweb.com/pipermail/personal_submersibles/attachments/20160215/3125d9a3/attachment.html>