[PSUBS-MAILIST] 3 phase power

k6fee via Personal_Submersibles personal_submersibles at psubs.org
Fri Aug 4 13:57:21 EDT 2017


Hi Hank,
The capacitors are there to create the sudo phase shift along with the windings in the motor/converter. Turning the rotor consumes power (unless you can circumvent the laws of physics. Haha), causing the reduced power output. The solid state units don't suffer this as there is no moving rotor.
Keith T.


Sent from my Verizon, Samsung Galaxy smartphone
-------- Original message --------From: hank pronk via Personal_Submersibles <personal_submersibles at psubs.org> Date: 8/4/17  10:28 AM  (GMT-08:00) To: Personal Submersibles General Discussion <personal_submersibles at psubs.org> Subject: Re: [PSUBS-MAILIST] 3 phase power 
Thanks Kieth,I thought the power less was only if you did not have capacitors and just relied on the third phase from the idler motor.I will check the surplus centrethanks againHank

On Friday, August 4, 2017, 10:45:03 AM MDT, k6fee via Personal_Submersibles <personal_submersibles at psubs.org> wrote:

Hank,
I have a rotory converter on my boat. Keep in mind you will only get about 2/3 of the input power on the output as some losses are acrewed to spin the converter. Also 208 volt motors will run on 220 just a bit faster than on 208.
There are solidstate converters out there, no rotating parts and more power . Check 
 www.surpluscenter.com

Keith T.







Sent from my Verizon, Samsung Galaxy smartphone
-------- Original message --------From: hank pronk via Personal_Submersibles <personal_submersibles at psubs.org> Date: 8/4/17  9:14 AM  (GMT-08:00) To: Personal Submersibles General Discussion <personal_submersibles at psubs.org> Subject: [PSUBS-MAILIST] 3 phase power 
Hi All,I need some input on converting single phase power to 3 phase.  I am thinking about going with a rotary phase converter for the two small motors on the lathe.  I am not sure though if my 208 V motors can handle 220-240 volt power.  I need to check my power source but it will be at least 220 I am guessing.  Maybe I need to use an inverter with variable output power if that exists?Hank_______________________________________________
Personal_Submersibles mailing list
Personal_Submersibles at psubs.org
http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.whoweb.com/pipermail/personal_submersibles/attachments/20170804/539ea450/attachment.html>


More information about the Personal_Submersibles mailing list