[PSUBS-MAILIST] Fw: lathe arrives at new shop

[Alan via Personal_Submersibles]

Hank,
where it protrudes up through the living room floor just put a table over it,
no one will notice till it starts up!
That's pretty quick going, congratulations, I would like to see it installed.
Alan
Sent from my iPad

> On 15/07/2017, at 11:26 AM, hank pronk via Personal_Submersibles <personal_submersibles at psubs.org> wrote:
> 
> I can't believe it, one week ago I find and buy my 26,300 lb vertical lathe.  Today it has arrived at my new shop.  It will take at least 8 hr to jack and roll it off the low bed trailer.  After it is off and the truck is gone, I have to lower it and roll it into the shop, but first I have to remove the exterior wall and cut a hole in the ceiling of the shop.  There is a two bedroom apartment above the shop, so now there will be a section of lathe poking through  the living room floor.  I am renovating the exterior of the shop anyways.er
> Hank
> 
> 
> On Friday, July 14, 2017 5:13 PM, xxx xxxxx <mp13 at live.ca> wrote:
> 
> 
> <Image 2017-07-14 at 5.13 PM.jpeg>
> 
> 
> <Image 2017-07-14 at 5.13 PM.jpeg>
> _______________________________________________
> Personal_Submersibles mailing list
> Personal_Submersibles at psubs.org
> http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.whoweb.com/pipermail/personal_submersibles/attachments/20170715/6c6f762e/attachment.html>