[PSUBS-MAILIST] OTS and motor controller noise

[Sean T. Stevenson via Personal_Submersibles]

Two things I would look at:

1) Relative location and shielding between the motor controller and the transducer cable. Is additional shielding (conduit?) possible?

2) I have encountered problems in the past with noise on coax due to impedance mismatch / partial signal reflection at any connectors. In my experience, this is solved by moving from RG58 up to RG8, but you don't have that option because the transducer is a potted assembly. If you have enough cable tail available to experiment, I wonder about swapping the SMA connectors for PL259 to see if that makes a difference.

Are you certain that the noise you are hearing is being introduced electrically, and not acoustically in the ultrasonic range of the transducer?

Sean

-------- Original Message --------
On 2025-04-28 06:47, Jon Wallace via Personal_Submersibles  wrote:

> Hey folks,
>
> My OTS STX-101 receiver is picking up some fairly significant and annoying electronic noise from my Roboteq PWM motor controllers. I tried changing channels on the OTS hoping a different frequency might help but it didn't. I also tried changing the controller PWM frequency between a range of 10khz and 24khz but nothing between those frequencies made a significant improvement. The noise is enough to override the normal squelch setting but at the same time a strong communication signal through the OTS transducer is enough to override the noise.
>
> My configuration has the transducer outside the hull and receiver inside the hull which required cutting the cable. I potted the cable in a thru-hull and reconnected the cable inside the cabin with RG-58 SMA connectors (soldered, not crimped).
>
> In talking with a couple other folks it seems I am not alone in this experience. Some others have found that using local batteries instead of tying into the same batteries used by the motors has significantly reduced the noise, however in my case I am already using a separate battery isolated from the motor batteries. Another choice that has seemed to make a difference is mounting an SB-1001 outside the hull and running the headset wires through the hull instead.
>
> Anyone else have similar experiences with OTS?
>
> Jon
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.whoweb.com/pipermail/personal_submersibles/attachments/20250428/3461b6c7/attachment.html>