George's favorite goop--RTV. You take the handle and follower off and run
the screws through the hull along with the shaft. Let it set, snug it up, stick
the handle back on and you've got a done deal. Sounds awful, but it worked
just fine and cost a grand total of about a dollar two-ninety-eight, plus
valve.
-----Original
Message-----
From: ShellyDalg@aol.com
To:
personal_submersibles@psubs.org
Sent: Thu, Mar 4, 2010 11:17 am
Subject:
Re: [PSUBS-MAILIST] MBT Vents
How is the valve handle sealed at the point where it penetrates the hull ?
I've seen both configurations but couldn't see how the handle penetration is
sealed.
Frank D.