Mercruiser stern legs have a tilt angle which does about 45
degrees. It has a gauge and it is waterproof so if it is filled with oil it
would be diveproof. Don’t know what the cost is but it it about 2” diameter
and about an inch high. I am looking to use these. Hugh From:
owner-personal_submersibles@psubs.org
[mailto:owner-personal_submersibles@psubs.org] On Behalf Of ShellyDalg@aol.com For a sensor to detect rudder angles or dive plane angles,
Minnkota and Lenco have the setup built into the trim tab actuators/switches.
The system is a little pricey though. The Minnkota actuators with a 4 inch
stroke are $259 for the actuator alone, and another $80 for the switch with LED
graph. As an alternative, it should be possible to use the idea suggested
by Alan. He mentioned a magnet coupled to a simple "string" of
magnetic switches, wired to an LED display inside the sub. In my application, it could be set up on the linkage controlling
the dive planes or rudders. The number of wires would be determined by how many
magnetic switches are used. I'm thinking 5 would suffice. One for center and
two on each end for half way and full stroke. The whole thing could be potted
in epoxy making it waterproof. Replacement of any individual part would be
fairly inexpensive. The magnetic switch "strings" could be fabricated
and kept as a "spares", the magnet attached to the linkage with a
screw, and a small epoxied thru-hull. The internal display is the same, Low
tech and cheap to build, easy to replace. Keeping it simple is the key to low
cost and reliability. I bet you could even find the magnetic switch
"strings" and internal LED graph parts as off-the-shelf items. You'd
have to seal them up ( potting in epoxy ) your self and make a mount
specific to your application, but replacing a blown part would be easy. Frank D.
__________ Information from ESET NOD32 Antivirus, version of virus signature database 4926 (20100308) __________ The message was checked by ESET NOD32 Antivirus. http://www.eset.com |