[PSUBS-MAILIST] Electrical thru-hull

[James Frankland via Personal_Submersibles]

Hi Bob,
I had exactly the same problems.  As others have said, forget the honing
tool.    I used the appropriate sized hand reamer.  (A normal one, not an
adjustable which are a bit of a pain to use).  I ran the reamer through and
then I used a bar with a slot cut in it and a piece of very fine emery
paper (wet) through the slot to take off the smallest amounts until the
fitting went through.  Worked fine.

Have a picture here.
http://www.guernseysubmarine.com/Extended_files/Page23356.htm
Hope this helps,
Good luck
James
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.whoweb.com/pipermail/personal_submersibles/attachments/20141009/6272f22f/attachment-0001.html>