[PSUBS-MAILIST] Electrical thru-hull

[Pete Niedermayr via Personal_Submersibles]

James, Was it the same for the MBT thru-hull ?

Pete

--------------------------------------------
On Thu, 10/9/14, James Frankland via Personal_Submersibles <personal_submersibles at psubs.org> wrote:

 Subject: Re: [PSUBS-MAILIST] Electrical thru-hull
 To: "Personal Submersibles General Discussion" <personal_submersibles at psubs.org>
 Date: Thursday, October 9, 2014, 4:50 AM
 
 Hi
 Bob,I had exactly the same problems.  As others
 have said, forget the honing tool.    I used the
 appropriate sized hand reamer.  (A normal one, not an
 adjustable which are a bit of a pain to use).  I ran the
 reamer through and then I used a bar with a slot cut in it
 and a piece of very fine emery paper (wet) through the slot
 to take off the smallest amounts until the fitting went
 through.  Worked fine. Have a
 picture here.  http://www.guernseysubmarine.com/Extended_files/Page23356.htmHope
 this helps, Good luckJames 
 -----Inline Attachment Follows-----
 
 _______________________________________________
 Personal_Submersibles mailing list
 Personal_Submersibles at psubs.org
 http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles