[PSUBS-MAILIST] Electrical thru-hull

[James Frankland via Personal_Submersibles]

Hi Pete,

Not sure which one you mean?  Where the vent pipe attaches to the MBT?
or
Where the through hull for the vent valve welds into the conning tower?
or
something else?
James

On 9 October 2014 11:30, Pete Niedermayr via Personal_Submersibles <
personal_submersibles at psubs.org> wrote:

> James, Was it the same for the MBT thru-hull ?
>
> Pete
>
> --------------------------------------------
> On Thu, 10/9/14, James Frankland via Personal_Submersibles <
> personal_submersibles at psubs.org> wrote:
>
>  Subject: Re: [PSUBS-MAILIST] Electrical thru-hull
>  To: "Personal Submersibles General Discussion" <
> personal_submersibles at psubs.org>
>  Date: Thursday, October 9, 2014, 4:50 AM
>
>  Hi
>  Bob,I had exactly the same problems.  As others
>  have said, forget the honing tool.    I used the
>  appropriate sized hand reamer.  (A normal one, not an
>  adjustable which are a bit of a pain to use).  I ran the
>  reamer through and then I used a bar with a slot cut in it
>  and a piece of very fine emery paper (wet) through the slot
>  to take off the smallest amounts until the fitting went
>  through.  Worked fine. Have a
>  picture here.
> http://www.guernseysubmarine.com/Extended_files/Page23356.htmHope
>  this helps, Good luckJames
>  -----Inline Attachment Follows-----
>
>  _______________________________________________
>  Personal_Submersibles mailing list
>  Personal_Submersibles at psubs.org
>  http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles
>
>
> _______________________________________________
> Personal_Submersibles mailing list
> Personal_Submersibles at psubs.org
> http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.whoweb.com/pipermail/personal_submersibles/attachments/20141009/ab35c163/attachment.html>