[PSUBS-MAILIST] Electrical thru-hull

[via Personal_Submersibles]

Thanks for all the input.  I am going to try it this weekend and will give you all an update!! 

----- Original Message -----

From: "submersibles, personal" <personal_submersibles at psubs.org> 
To: "submersibles, personal" <personal_submersibles at psubs.org> 
Sent: Thursday, October 9, 2014 2:50:45 AM 
Subject: Re: [PSUBS-MAILIST] Electrical thru-hull 

Hi Bob, 
I had exactly the same problems.  As others have said, forget the honing tool.    I used the appropriate sized hand reamer.  (A normal one, not an adjustable which are a bit of a pain to use).  I ran the reamer through and then I used a bar with a slot cut in it and a piece of very fine emery paper (wet) through the slot to take off the smallest amounts until the fitting went through.  Worked fine. 
  
Have a picture here.  
http://www.guernseysubmarine.com/Extended_files/Page23356.htm 
Hope this helps, 
Good luck 
James 
  

_______________________________________________ 
Personal_Submersibles mailing list 
Personal_Submersibles at psubs.org 
http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.whoweb.com/pipermail/personal_submersibles/attachments/20141009/557b46a6/attachment.html>