[PSUBS-MAILIST] printing

[hank pronk via Personal_Submersibles]

Alec,
Thanks' for putting that to bed.  Perhaps machining parts from blocks of plastic.  I have some experience machining plastic and it was a treat. Deep Rover has ABS pipe members with ss liners, the member is the cylinder, sweet.
Hank --------------------------------------------
On Sun, 4/12/15, Alec Smyth via Personal_Submersibles <personal_submersibles at psubs.org> wrote:

 Subject: Re: [PSUBS-MAILIST] printing
 To: "Personal Submersibles General Discussion" <personal_submersibles at psubs.org>
 Received: Sunday, April 12, 2015, 1:46 PM
 
 Hi
 Hank,
 Generally speaking you
 are limited to relatively small pieces and they take a long
 time. It is of course not impossible, but most likely not
 the most efficient approach, at any rate with small printers
 like mine. 
 Best,
 
 Alec
 On Sun, Apr 12, 2015 at
 1:32 PM, hank pronk via Personal_Submersibles <personal_submersibles at psubs.org>
 wrote:
 Gamma
 will need two new opposing manipulators.  I am wondering if
 it is possible to print the arm members.  Is it
 practical?  I am trying to create an almost weightless arm
 set up.
 
 Hank
 
 _______________________________________________
 
 Personal_Submersibles mailing list
 
 Personal_Submersibles at psubs.org
 
 http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles
 
 
 
 -----Inline Attachment Follows-----
 
 _______________________________________________
 Personal_Submersibles mailing list
 Personal_Submersibles at psubs.org
 http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles