[PSUBS-MAILIST] penetrator

[hank pronk via Personal_Submersibles]

Brian, I try to have as much separation as possible just to ensure they don't make contact, but 1\16 inch has worked fine for me.  If you have 4 rods it will be crowded for putting wire connectors on.  You can always bend the rods to make clearance also.  Hank 

    On Friday, December 16, 2016 5:49 PM, Brian Cox via Personal_Submersibles <personal_submersibles at psubs.org> wrote:
 

 Hank,   Starting to work on my electrical penetrators for my motor pods .   I need to run 4  - 1/4"  copper threaded rods thru a penetrator  what kind of separation between them is adequate ?  or should I break it up into two penetrators? Brian 

--- personal_submersibles at psubs.org wrote:

From: hank pronk via Personal_Submersibles <personal_submersibles at psubs.org>
To: Personal Submersibles General Discussion <personal_submersibles at psubs.org>
Subject: [PSUBS-MAILIST] penetrator
Date: Fri, 16 Dec 2016 23:01:23 +0000 (UTC)

Hi All,I am looking for a penetrator supplier,  I am hoping to find male ends for some penetrators I have.

Hank_______________________________________________Personal_Submersibles mailing listPersonal_Submersibles at psubs.orghttp://www.psubs.org/mailman/listinfo.cgi/personal_submersibles
_______________________________________________
Personal_Submersibles mailing list
Personal_Submersibles at psubs.org
http://www.psubs.org/mailman/listinfo.cgi/personal_submersibles


   
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.whoweb.com/pipermail/personal_submersibles/attachments/20161217/2f4767e6/attachment.html>