|
Cliff, Thanks for the input on LABoiler, I will check them out. Also does
anyone know of a source for cast acrylic domes 2 - 3 inches thick.
Thanks,
Jim Kocourek
----- Original Message -----
Sent: Thursday, May 04, 2006 10:01
AM
Subject: Re: [PSUBS-MAILIST] Need a
machine part?
I purchased my heads from LA Boiler Works http://www.laboiler.com. My heads
were semi elliptical but I am sure they carry hemispherical as well.
Cliff
----- Original Message -----
Sent: Thursday, May 04, 2006 6:47
AM
Subject: Re: [PSUBS-MAILIST] Need a
machine part?
Can anyone give me an idea about a good US source for hemispherical
heads. I have a quote for 5/8 steel by 48 inch diameter at $2,600.00. I
don't know enough to know if this is a good price or not. Maybe someone has
another source I can check.
Thanks,
Jim Kocourek
----- Original Message -----
Sent: Thursday, May 04, 2006 12:21
AM
Subject: Re: [PSUBS-MAILIST] Need a
machine part?
Actual link is:
They've been around a while and have basically the best online
machine-shop service in the world from what I've seen. Very
useful. I've never used em as I have no projects goin at this time,
but I plan on it for sure if I have the money to burn.
----- Original Message -----
Sent: Wednesday, May 03, 2006 9:09
PM
Subject: [PSUBS-MAILIST] Need a
machine part?
Here's a link I thought someone here may find of use, or at least
of interest. I can't vouch for them, and I know nothing about
them, but it sounds like they could be useful...
Stan
|