[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [PSUBS-MAILIST] Rudder angle indicators



Group,
How about a semi-circle of reed switches, 5, 7, or 9 depending on how
fine a readout, connected to individual LEDs and activated by a small
magnet on the rudder/dive plane shaft?
The LEDs could be green at neutral, then amber, orange,red, etc.
Jim R.

On Sun, Mar 14, 2010 at 5:04 PM, Jens Laland <laland@artematrix.org> wrote:
> The 'signal source' can be a potentiometer or a 10-throw switch, etc. The
> main issue is that it represents a linear, variable (analog or discrete
> steps) voltage divider (and I believe the circuit should handle the supply
> voltage on board).
>
> Tomorrow, when back in the workshop, I'll put together a preliminary
> circuit diagram and part list, and make that available.
>
> Personally, I want to try out a simple, homemade inductive angle sensor
> instead of a pot-meter, as I think it would be a lot easier to waterproof
> a pair of coils [ref. attached image].
>
> However, if that will work, then I would also need to handle AC signals,
> which again requires a different circuits.
>
> There was a few other questions asked, but I'll tend to those to morrow.
>
> Best regards,
> Jens Laland



************************************************************************
************************************************************************
************************************************************************
The personal submersibles mailing list complies with the US Federal
CAN-SPAM Act of 2003.  Your email address appears in our database
because either you, or someone you know, requested you receive messages
from our organization.

If you want to be removed from this mailing list simply click on the
link below or send a blank email message to:
	removeme-personal_submersibles@psubs.org

Removal of your email address from this mailing list occurs by an
automated process and should be complete within five minutes of
our server receiving your request.

PSUBS.ORG
PO Box 53
Weare, NH  03281
603-529-1100
************************************************************************
************************************************************************
************************************************************************